AEG DRYER DOESN’T WORK AT ALL

Has your Zanussi dryer stopped working?

THIS APPLIES TO THE CURRENT ZANUSSI MODEL WITH ON/OFF SWITCH BENEATH THE PROGRAM BUTTON.
(with and without display)

Problem description:

• Your machine does not work at all. No lights, no ‘beeps’.
• The power cord is connected to an outlet and the outlet has power.
• You did not experience problems before with the machine.

If this matches your situation, the PCB of your machine might be out of order.

In your case, a new PCB would cost between € 200 and € 275.
But don’t worry. I can repair PCB for you.

What should you do?

Double-check if the machine is realy out of order
Before you signup for repair, first double-check whether your machine realy has a defect. So no more lights or beeps when you switch the machine on – and check whether there is voltage on the outlet.

Signup for repair
If the machine still doesn’t work, then you can signup for repair.

How to dis-assemble the PCB

The PCB that we need is the print on the right side. Nr. 587 in the drawing.

Remove the top from the machine by unscrewing 2 screws on the back of the top and 1 behind the condensation tray.

Unscrew the right side panel, these are the screws on the back.

You will now see the 2 screws that secure the circuit board to the machine.

Take the covers of the printed circuit board and disconnect all plugs.

You do not have to loosen the print any further, just send the entire housing to us.

This applies to all tumble dryers with the ON / OFF BUTTON under the program switch.

We repair – among others – to the following models:
AEG Lavaterm 65270AC
Zanussi ZDH8333W
Zanussi ZDC8203P
Zanussi ZDC8203W
Zanussi ZDH7332P
Zanussi ZDH7332PZ
Zanussi ZDH8333P
Zanussi ZDP7202PZ
Zanussi ZDP7203P
Zanussi ZTE7100PZ
Zanussi ZTE7101PZ