THIS APPLIES TO THE NEW MODEL WITH THE ON/OFF SWITCH BENEATH THE PROGRAM BUTTON
- Your machine does not work at all. No lights, no ‘beeps’. Or error code EH0 is displayed.
- The power cord is connected to an outlet and the outlet has power.
- You did not experience problems before with the machine.
If this matches your situation, the PCB of your machine might be out of order.
In your case, a new PCB would cost between € 200 and € 275.
But don’t worry. I can repair PCB for you.
What should you do?
Double-check if the machine is realy out of order
Before you signup for repair, first double-check whether your machine realy has a defect. So no more lights or beeps when you switch the machine on – and check whether there is voltage on the outlet.
Signup for repair
If the machine still doesn’t work, then you can signup for repair.
How to dis-assemble the PCB
The PCB that we need is the print on the right side. Nr. 587 in the drawing.
Remove the top from the machine by unscrewing 2 screws on the back of the top and 1 behind the condensation tray.
Unscrew the right side panel, these are the screws on the back.
You will now see the 2 screws that secure the circuit board to the machine.
Take the covers of the printed circuit board and disconnect all plugs.
You do not need to loosen the print further, just send the entire housing to us.
This applies to all tumble dryers with the ON / OFF BUTTON under the program switch.
We repair – among others – to the following models: